So after printing it in a transparently blue PLA filament from polymakr, I decided to try out some of the flexible filaments I've had on hand for awhile but have done nothing more than print a sample chip out .
I tried printing out with this type of filament before, and failed, mostly because either the extruder that I was using caused the filament to buckle and just wrap itself around the stepper motor, or after extruding a bit for the first few layers would just stop extruding as the gripper gear would just lose its grip and not push the filament along ending up in "air prints".
Being that I have about 15 rolls of various flex materials I figured I better start using these filament and decided to try various methods of getting these filament to print correctly. (read and see more after the jump!)